CNI widgets
Serial port scan trigger device
GE physiological data monitor
Circuit tidbits
RS232 level converter
We need a little circuit to take the scanner data stream (-12v to +12v) and allow it to be safely ready by our 5v microprocessor. We just took the Tx part of this simple RS232 level converter. We used a 2N3904 transistor with emitter to ground, collector to the UART Rx pin on the microcontroller with a 10k pull-up resistor to the 5v line, and the base connected to the Tx line coming from the scanner via a 4.7K resistor, with a 4.7k pull-down to ground.